Upload to vmeMega board fails using:
$ make upload_<target name>
, but succeeds with normal r3 mega board.
Workaround is to disable flash memory erase by adding -D option after the avrdude command.
To get avrdude command run the next line and copy-paste:
$ make upload_<target name> VERBOSE=1
output of $ make upload_<target name>:
[100%] Uploading /home/ebert/projects/ocs-base/build/mega2560/bin/amc7812_stream.hex to atmega2560 using wiring
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.01s
avrdude: Device signature = 0x1e9801
avrdude: NOTE: "flash" memory has been specified, an erase cycle will be performed
To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: stk500v2_command(): command failed
avrdude done. Thank you.
Upload to vmeMega board fails using:
$ make upload_<target name>, but succeeds with normal r3 mega board.
Workaround is to disable flash memory erase by adding -D option after the avrdude command.
To get avrdude command run the next line and copy-paste:
$ make upload_<target name> VERBOSE=1output of
$ make upload_<target name>: