- Arduino Uno Board [x1]
- Breadboard [x1]
- Flex Sensor (2 in, 30k (straight) to 100k (bent) ohm) [x1]
- 100k ohm Resistor [x1]
- Male-to-Male Jumper Wire [x5]
- Depending on the flex sensor's resistance, we will need a resistor with the sensor's maximum possible resistance for the voltage divider circuit.
- To get the flat resistance, use a multimeter on the unbent flex sensor.
- To get the bend resistance, use a multimeter on the flex sensor after bending it 90 degrees.