BEEP BEEP when done writing a disk (after slow transfer)

[fredsa]

Transferring disks over audio takes a long time, several minutes.

It would be lovely to have a friendly BEEP BEEP to tell you the transfer completed successfully. (And perhaps BEEP BEEP BEEP if there was an error).

This feature should probably be limited to audio transfers as the other methods are (I imagine) much faster, and allow the user to "stay awake" during the process of copying 140KB of data.

[fredsa]

The message that appears in ADTPro 2.1.0 after 'WRITING BLOCK 00280 OF 00280' is:

COMPLETE!
PRESS A KEY TO CONTINUE...

When this message is displayed, BEEP BEEP :)

[david-schmidt]

I see the documentation says it beeps on "finish or abort." I actually see beeping in the code for abort and for errors.
Enable_Sound

I'm not a great fan of sound myself, but I suppose it should at least match the doc...

[fredsa]

I'm no fan of loud beeps either. It's the use case of audio transfers taking several minutes, too long to sit there and watch, that's the driving factor for me.

The result is that I'll start doing something else and "forget" to check on the transfer.

A single beep when done transferring (when ENABLE SOUND is set to YES) would be very welcome and would make these very slow transfers go a bit faster.

Also, forgot to mention: ADTPro is awesome. Thank you!